Best 3D printers for ABS, ASA and nylon
Updated 21 May 2026 · Live prices on every page load from Amazon.se
Engineering materials need an active heated chamber and a hot end that clears 280 °C. Without both, ABS warps off the bed and nylon comes out brittle. These are the printers that can do the job properly.
No verified printers match this use case on Amazon.se right now.
No listings match your current marketplace selection - tick more sources above.
Matt's take
A brief reality check before you spend engineering-material money: you also need a filament dryer for nylon, a decent enclosure fan for ABS fumes, and patience for the tuning pass each new spool demands. A printer with 300 °C and an active chamber is necessary but not sufficient. Budget a hundred on top for drying and filtration; it stops being optional the first time a 24-hour nylon print delaminates halfway through. Also: PC draws more heat than anything on this list - if you specifically need polycarbonate, double-check the chamber-temperature rating, not just the hot-end rating.
Frequently asked
Can a cheap printer print ABS if I put it in a box? +
A passive enclosure helps with draughts but does not replace an actively heated chamber. Warping on anything larger than a phone case is almost inevitable without ~55-60 °C chamber temps. If your budget is tight, print ASA instead - it handles draughts and UV far better than ABS for outdoor parts.
What hot-end temperature do I actually need for nylon? +
Plain PA6 / PA12 prints happily at 250-270 °C. Glass-filled and carbon-filled nylon wants 280-300 °C and a hardened nozzle because the fibre content chews brass. If a printer caps at 260 °C, cross nylon-CF off your shopping list.
Do I need a dryer for nylon or can I skip it? +
You cannot skip it. Nylon absorbs enough moisture in a few hours of open air to print as if it is popping popcorn. A sub-£100 filament dryer is not optional kit for nylon or PA-CF - it is part of the printer.
Is polycarbonate possible on these printers? +
PC needs ~70-80 °C chamber temperatures and 290-300 °C hot ends. Most "active chamber" printers listed here target ABS/ASA chamber temperatures (~50-55 °C). Check the spec sheet for rated chamber temperature, not just hot-end temp.
Related reading
Ranking is spec-driven. It favours printers that objectively have the capabilities this shortlist targets. Firmware, support quality and long-term reliability aren't on the spec sheet - read the full printer page and owner reports before committing.
