Portrait
Updated 21 May 2026 · Live prices on every page load from Amazon US + UK
Buy on Amazon.com - $599.99 →Affiliate link. Price live from the marketplace, not cached.
At a glance
What this printer gets right and wrong
Nothing jumps out on the spec sheet as a standout feature at this price.
- ! Bedslinger design - expect ringing artefacts on tall prints at speed.
Head-to-head spec + price table against the KODAK Portrait. Verified printers on this marketplace only.
Sensible first-printer territory: priced where you can afford to get it wrong, with auto-levelling so the first layer isn't a ritual. You'll outgrow it in 18 months, which is fine.
Bedslinger with middling flow rate - you already have one of these. The whole point of upgrading is speed, rigidity, or print quality that your current machine can't hit. This doesn't clear that bar.
No active heated chamber or a hot end that tops out below 280°C means no reliable ABS, ASA, nylon or PC. Fine for a hobbyist, wrong tool for commercial work in engineering materials.
Verdicts are rule-driven from the spec sheet and current price ($600). They don't capture firmware polish, support quality, or reliability - so treat them as a sanity check, not a final answer.
Live offers
Every live listing on the English-language Amazon marketplaces that I've matched to this printer. Cheapest first. Affiliate links.
- 🇺🇸 Kodak 3D Printer Portrait, White, 21.1 x 20.7 x 20.7 inAmazon.com · New$599.99View
Close alternatives - what $600 gets you elsewhere
Think of this like the shopping-cart upsell: here's what a tenner more or less could buy you in roughly the same category. Same FDM tech, same marketplace, all prices live. Stretches are data-driven; they're not sponsored placements.
Save the money, similar specs on paper. You'd give up: 9.4 L vs 5.8 L build volume, 295°C hot end vs 280°C.
Get: 17.6 L more build volume (27.0 L) · 300°C hot end (was 295°C).
Get: 54.6 L more build volume (64.0 L).
Frequently asked
What materials can the KODAK Portrait print? +
At $600 the KODAK Portrait has the hot end for engineering materials (295°C) but no active chamber, so ABS and nylon will warp on anything larger than a phone case. Treat it as a PLA/PETG/TPU workhorse with headroom for the occasional small ABS part.
How big can I print on the KODAK Portrait? +
200×200×235 mm (9.4 L). Mainstream bed size - fits 90 % of what people actually print. Cosplay helmets will need to be sliced into sections.
Is the KODAK Portrait worth $600? +
$600 is serious hobbyist territory. For the KODAK Portrait to justify this over a $500 machine it needs to deliver genuine speed (volumetric flow), reliability at speed, or access to engineering materials. Check the spec table above against those three.
